MY ACCOUNT
WISHLIST
COMPARE LIST
Hello.
Username*
Password*
Lost password?
Email*
High quality standard 1/2′ SME type, 4 pin, turntable connector Fits most turntables with S shaped tonearm
The Measure it Stylus Tracking Force Gauge is a highly accurate electronic balance that is designed for measuring stylus trackingforces up to 5.0 grams in 0.001 gram increments. Each Measure it S2 can easily be calibrated with the included calibration weight. The Measure it S2 has a solid aluminum housing with a 4-digit LCD backlit display. Whenever in doubt about the actual amount of pressure on the diamond tip the 4 digit display of this smart tool will help. Armed with precise information about tracking force, your stylus tip wear can be significantly reduced.
The lightweight aluminum AT-HS10SV is a universal ½”-mount headshell for 4-pin turntable cartridges. Featuring an aluminum die-cast body, the AT-HS10 is designed to keep vibration to the bare minimum. The finger lift is positioned near the front of headshell to enable precise placement of the stylus onto the record. The headshell is equipped with gold-plated lead wires for lossless signal transmission and comes with mounting screws
There have been a broom since the early 70s and do their job sometimes well but less well. A commonly observed phenomenon is the so-called “storm”, or “skating”, the broom arm towards the center of the plate without running synchronously with the sampling needle. The latest developments therefore also consistently rely on measures that prevent exactly that. With the highly effective neodymium magnet a material has been available for quite some time, which can be used right here. Sweep it S2 was developed in collaboration with Klaus Mick and uses its patented principle to magnetically stabilize the broom An intensive research and development of technical and physical properties and empirical experimental arrangements have led to the product that you hold straight in your hands.
New Highest quality turntable belt, 16.9″/40,64 cm Inside Circumference x 0.200″/ 0,50 cm Wide x 0.030″/ 0,076 Thick Turntable Belt
New Highest quality turntable belt, 27.3″/69,34 cm Inside Circumference x 0.200″/ 0,50 cm Wide x 0.024″/ 0,060 Thick Turntable Belt
This is a brand new generic replacement flat rubber belt.- manufactured to meet or exceed the Original Equipment Manufacturers specifications. .046 Inch / 1.2mm Thick and Wide 15.2 Inch / 38.1cm Inside Circumference (total length)
This is a brand new generic replacement flat rubber belt.- manufactured to meet or exceed the Original Equipment Manufacturers specifications. Size : 23.6″ by 0.200″ wide
This hand-built cartridge uses the acclaimed Gyger II nude diamond stylus. A fine-line elliptical type with a 6 µm small radius it gives smooth, extended highs, low distortion and reproduces a highly detailed and dynamic sound. Advanced diamond tip polishing ensures excellent tracking ability and reduces record wear. Because it fills the record groove more completely due to its larger major radius, the Gyger II represents a major upgrade over normal elliptical stylus types.
The AT-VM95ML/H combo kit includes the AT-VM95ML dual moving magnet cartridge premounted on the AT-HS6BK headshell.
DesignClosed-back dynamic
Touch Control✓
Driver Diameter45 mm
Frequency Response15 – 28,000 Hz
Battery LifeApprox. 40 hours continuous use
Charging TimeApprox. 7 hours (for 0-100% charge)
MicrophoneOmnidirectional condenser
Communication SystemBluetooth Version 5.0
Support CodecaptX, AAC, SBC
The ATH-SR6BTBK Wireless Over-Ear Headphones let you enjoy amazing, high-fidelity audio whether you choose to listen over a traditional wired connected or via Bluetooth wireless technology. The headphones are compatible with Qualcomm aptX, AAC and SBC codecs, and connect easily with smartphones, tablets, music players, and other devices. Adding devices in the headphones’ memory is made even easier with NFC (Near Field Communication) functionality, which enables touch pairing and connection with any compatible device.
The ATH-SR6BTBK features powerful 45 mm drivers that are capable of reproducing Hi-Res Audio (5–40,000 Hz frequency response) when used with the included 1.2 m (3.9′) cable. The cable is equipped with mic and controls so it can also be used to operate devices in areas where Bluetooth wireless technology is prohibited or when headphone battery power is low. For wireless use, the headphones have a mic and volume/control switch built into the left earcup, making it easy to answer calls, adjust volume and handle music and video playback (play, pause, fast-forward, reverse, next/previous track).
One place a DJ can’t compromise, is in how they hear their mix. The Numark HF-125 headphone set delivers the goods with flexible 7-position independently adjustable dual ear cups, large 40mm Mylar speaker drivers, 6’ tangle-resistant cord with a molded 1/8” TRS connector and a 1/8” to ¼” TRS adapter, and padded headband and ear cups.
The AT-HPH300 Headphone Hanger is a convenient tool for safely storing your headphones in areas where space is limited. The hanger features an adjustable clamp that mounts securely to a shelf, desk or other surface up to 3.5 mm (1.4″) thick. The hanger rotates 360°, allowing you to store headphones unobtrusively under the desk or shelf, or have out and at the ready to quickly grab when needed. And with the hanger’s soft leatherette pad, you never have to worry about your headphones getting scratched or damaged. A great space-saving solution.
VERTIGAIN® technology helps to increase quality and clarity by up to 10% compared to other digital USB microphones. As sound waves move in a vertical direction, the wave reaches the 3 condensers without being scattered by any microphone mesh.
4 Dedicated Recording Modes
The MDRILL One will be only mic you need!
4 different polar settings offer the ultimate flexibility. Record vocals, instruments, podcasts, interviews, conference calls, streaming and much, much more!
Simply press the mode button and choose between Cardioid, Stereo, Bi-Directional or Omni-Directional patterns to find the best performance setting. So, whether you stream from home or need to record your next masterpiece, the MDRILL One Pro will help you produce studio-quality recordings – every time.
Package Content: Thronmax Mdrill One Black 48khz, Fabric Travel Case, Dust-proof Protective Sleeve, Foam Windshield, Pop Filter, User Guide, 3 meters Type C braided cable, Advanced Boom Adapter, 3/8” Female, 5/8″ Male Adapter
System Requirements: PC/Mac, Windows 8/Windows 7/Windows Vista, Mac OS X (10.7-10.9)
Product Code: M2P-B Jet Black 96 Kit
VERTIGAIN TECHNOLOGY®
VERTIGAIN technology® allows recording in unparalleled broadcast quality, with up to 10% more clarity & accuracy than other USB microphones.
2 Recording Patterns
Cardioid and Omni-directional. For different application you can choose one of them. Cardioid mode mostly use for Vocal recording , omnidirectional mode for video conference or for meeting applications.
Record audio for your podcast straight to your computer with the Marantz Professional MPM-4000U, a USB microphone geared toward content creators. Bypassing the need for any audio interface, preamp, or mixer, the MPM-4000U lets you record yourself right out of the box, capturing broadcast-quality audio in the process.
Monitor audio straight from the mic with the headphone jack. Use controls typically only found on mixers to tailor the sound: mute the mic, control its gain, and adjust the volume on your headphones independently. The mic ships with a desktop mic stand, a mic clip, and a USB cable to get you up and running right away.
0.3 mil Diamond conical tip needle , for 78rpm only , 3.0 – 5,0 grams tracking pressure
0.7 mil Diamond conical tip needle , 16 or 33 or 45rpm NOT for 78rpm, 1,0 – 3,0 grams tracking pressure
0.7 mil Diamond conical tip needle , 16 or 33 or 45rpm NOT for 78rpm , 1.25 grams tracking pressure
Orders shipped within 24 hours
0.7 mil Diamond conical tip needle , 16 or 33 or 45rpm NOT for 78rpm , 2.5 – 4 grams tracking pressure
$ 32.95
Red
Normarh, Audio Technica, Pfanstiehl
Conical
no
2.5-4 Grams
270-D
• AUDIO TECHNICA NEEDLES ATS-10 ATS10 ATS-10L ATS10L ATS-12C ATS12C, ASTATIC NEEDLES N482 N478 N481 N483, AT2500 AT-33 AT33 AT-330 AT330 AT-60 AT60 AT-68XC AT68XC AT-7110 AT7110 AT-910 AT910 AT-910B AT910B AT-960X AT960X CE12010 CS110II DJ714 N-10-100 N10100 TP111E X-11 X11, AUDIO TECHNICA CARTRIDGES VM8-7D VM87D AT-10 AT10 AT-10PQ AT10PQ AT-1110 AT1110 AT-2000 AT2000 AT-201 AT201 AT-2500, EVG NEEDLES PM2277DE PM2276D, MARANTZ NEEDLES 6370Q
Replacement JNP300 stylus with spherical tip and aluminium alloy cantilever. Stylus: 0.4 x 0.7 Mil naked elliptical block diamond stylus tip
Audio-Technica ATN91 stylus specified for AT91 cartridges, Special conical diamond tip for good fidelity ,0.6 mil Diamond Conical needle , 1.5 – 2.5 grams tracking pressure
Universal Replacement Stylus For 750 Stanton Cartridges
0.6 mil Diamond conical tip needle , 16 or 33 or 45rpm NOT for 78rpm , 1,0 – 2,0 grams tracking pressure