MY ACCOUNT
WISHLIST
COMPARE LIST
Hello.
Username*
Password*
Lost password?
Email*
The new PS2 MM phono preamp sounds very good and looks classy as well. It features all discrete circuitry and a very accurate RIAA curve. The gain is variable by a front panal volume control and is capable of up to 47 dB gain. This solves the age old complaint of volume between phono and other input sources. The front panel is brushed aluminum with an instrument grade power toggle switch. A basic RCA cable and mini plug are included in the package.
Features:
Superior audio performance
Front panel power on/off switch
Extemely accurate frequency response
OFC gold plated RCA cables included
Input and output via gold-plated RCA jacks
Sub-sonic filter to reduce deep rumble and wasted amplifier
All-steel case construction with LED power indicator and groud wire connection terminal
High current outboard power supply for low noise and improved audio dynamics
Variable output control for matching the turntable volume level to other connected audio sources
Extra 7dB “Boost” option available for use with very low output cartridges
Specifications:
RIAA Frequency Response: 20-20 kHz, +/- 0.5 dB
Sub Sonic Filter: 7 Hz
Signal-To-Noise Ratio: 80 dBA
Total Harmonic Distortion: 0.06%
Input Impedance: 47 kOhms/220 pF
Output Impedance: 600 Ohms
Gain: 40 dB nominal, plus up to 7 dB gain
BoostSensitivity – normal range: 3.0 mV (with volume control up to 2 o’clock position)
Sensitivity – “Boost” range: 1.5 mV (with volume control past 2 o’clock position/Boost mode)
Overload: 30 mV (20 dB)
Maximum Output: 3.5 Volts
Crosstalk (20-20 kHz): >55 dB
The highly-requested Spin-Clean SPINCLOTH drying cloths have returned!
Four times thicker, fluffier, softer, and more absorbent than the previous drying cloths, the new SPINCLOTH cloths remain easy-to-use, lint-free, and the washable.
Custom produced for Spin-Clean, the SPINCLOTH drying cloths offer even more absorbency when drying your just-cleaned vinyl. The SPINCLOTH drying cloths are non-abrasive and 100% cotton, adding the perfect finish to your “like-new” LPs and 45s.
Rewash cloths in washer with whites and bleach. Use one for cleaning and another for drying the record surface.
Qty: 1 package includes 5 drying cloths.
* Rigid magnesium alloy construction for improved cartridge performance
* Double lock pins for more accurate alignment on the tonearm
* Lead wires are 0.05 x 8 core high purity, silk-wrapped litz copper
* Adjustable azimuth at the collet (hex wrench included) * 11.2 gram weight, without cartridge
Wet type head cleaner and demagnitizer for all audio cassette tape deck playwea made car, home or portable features. Demagnetizes heads, cleans heads, automatically reverses when finished, cleans capstan, cleans pinch rollers.
NEW CONNOISSEUR BD-1, BD-2, BD-2/A, BD-2/AR, BD-3 Round Turntable Belt. Top Quality, Long Lasting and Hard to find, RBS32.2 x 0.070″
New Highest quality turntable belt, 24.5″/62,23 cm Inside Circumference x 0.200″/ 0,50 cm Wide x 0.023″/ 0,058 Thick Turntable Belt
NEW Genuine Pro-Ject Essential , Essential II & Essential III Replacement Drive Belt Also compatible with – Elemental/Elemental Phono USB – Primary/Primary Phono USB/Primary E – Essential/Essential Phono USB – Essential II/Essential II Phono USB/Essential II Digital – Essential III/Essential III A – George Harrison Record Player – VT-E – Xtension 9 – Juke Box E – Juke Box S2
New high quality super elasticity rubber drive belt 21′ long x 0.20′ width x 0.02′ thick ( 544mm long x 5mm width x 0.5mm thick) Application: Fits most all 10′ to 13′ diameter platter turntables Can replace all 21′ to 24.5′ belts (170 to 200mm BELT), Perfect replacement or belt, specs equal or exceed original standards.
The VM760SLC special line contact stylus cartridge is the flagship model in Audio-Technica’s
Nagaoka MP-110 the successor to the highly acclaimed and classic Nagaoka MP11 phono cartridge, the new Nagaoka MP-110 phono cartridge extends and strengthens its predecessor’s prowess and talents to a new level of radiance. You’ll hear more music, more detailed refinement The Nagaoka MP-110 is the cartridge to start with and to keep for a long time. Features -Superfine polished eliptical diamond bonded stylus -Powerfull samarium cobalt magnet -Lightweight aluminum alloy cantilever for high fidelity -Carbon fibre reinforced plastic shoe -Anti ferro magnetic permalloy shield casing. Stylus replacement: Nagaoka JN-P110 The stylus replacement interval varies depending on the using conditions. But for general use at home, the reference time is between 150-200 hours in which the stylus begin to wear and the tone quality deteriorates. Recommend replacing the stylus as aerly as possible to enjoy clear tone for a long time and not to damge the disc grooves.
The Audio-Technica Consumer AT-VM95SH Dual Moving Magnet Cartridge features a special coil design, which delivers a powerful output level with high channel separation and low distortion for remarkable tonal quality. The cartridge can be mounted to a standard 1/2″ mount and features integrated threaded inserts, allowing it to be mounted with just two screws (no nuts required).
The Shibata stylus has two radii, similar to an elliptical stylus, but longer and more narrow. This allows for more surface contact and effective pickup of ultra-high frequencies with less groove stress or distortion. All VM95 Series share the same body, allowing the stylus to be replaced with any of the six interchangeable AT-VMN95 replacement styli. The Audio-Technica Consumer AT-VM95SH ships with mounting hardware and a non-magnetic screwdriver.
High cost performance. Pop and jazz to the best high-performance, low-cost entry model MP-type stereo cartridge head shell with MP-100H ● output voltage: 5mV 5cm / sec
● frequency response: 20Hz ~ 20KHz
● Channel separation: 22dB 1KHz
● channel balance: 2.0dB following
● load resistance: 47KΩ ● load capacity: 100pF
● cantilever: aluminum alloy
● needle tip: 0.6mil cone and joining diamond
● proper needle pressure: 1.8 ~ 2.3g
● cartridge self-weight: 6.5g
● with head shell its own weight: 15.9g
DesignClosed-back dynamic
Touch Control✓
Driver Diameter45 mm
Frequency Response15 – 28,000 Hz
Battery LifeApprox. 40 hours continuous use
Charging TimeApprox. 7 hours (for 0-100% charge)
MicrophoneOmnidirectional condenser
Communication SystemBluetooth Version 5.0
Support CodecaptX, AAC, SBC
The AT-HPH300 Headphone Hanger is a convenient tool for safely storing your headphones in areas where space is limited. The hanger features an adjustable clamp that mounts securely to a shelf, desk or other surface up to 3.5 mm (1.4″) thick. The hanger rotates 360°, allowing you to store headphones unobtrusively under the desk or shelf, or have out and at the ready to quickly grab when needed. And with the hanger’s soft leatherette pad, you never have to worry about your headphones getting scratched or damaged. A great space-saving solution.
The ATH-WS990BT wireless over-ear headphones combine exclusive 53 mm Deep Motion Drivers with large, high-flux magnetic circuitry and Bluetooth technology to deliver vibrant full-range wireless audio with invigorating bass. The powerful magnetic force of the circuitry results in dynamic, well-tailored diaphragm response to reproduce deep, clear low frequencies and detailed mid-to-high frequencies.
One place a DJ can’t compromise, is in how they hear their mix. The Numark HF-125 headphone set delivers the goods with flexible 7-position independently adjustable dual ear cups, large 40mm Mylar speaker drivers, 6’ tangle-resistant cord with a molded 1/8” TRS connector and a 1/8” to ¼” TRS adapter, and padded headband and ear cups.
Audio-Technica’s stringent quality and consistency standards set the AT2020 apart from other mics in its class. Its low-mass diaphragm is custom-engineered for extended frequency response and superior transient response. With rugged construction for durable performance, the microphone offers a wide dynamic range and handles high SPLs with ease. The AT2020: the new standard for affordable side-address studio condensers.
VERTIGAIN TECHNOLOGY®
VERTIGAIN technology® allows recording in unparalleled broadcast quality, with up to 10% more clarity & accuracy than other USB microphones.
2 Recording Patterns
Cardioid and Omni-directional. For different application you can choose one of them. Cardioid mode mostly use for Vocal recording , omnidirectional mode for video conference or for meeting applications.
Ideal for podcasting, home studio recording, field recording, and voiceover use, the ATR2500x-USB plugs into your computer or other device, and functions seamlessly with your favorite recording software. This large-diaphragm, side-address cardioid condenser reduces pickup of unwanted sounds from the sides and rear, and is equipped with a high-quality analog-to-digital converter (24-bit, up to 192 kHz) for excellent fidelity.
The motiv mv88+ video kit is a premium digital stereo condenser microphone. Your new mobile recording rig directly connects to any apple device via a lightning connector, or via usb-c to select additional devices. The mv88+ has all you need to capture great content right out of the box. The included phone mount is also compatible with your existing set-up, allowing to connect to any standard ¼” tripod. The mv88+ is compatible with: Ios devices, samsung galaxy note 8, samsung galaxy note 9, samsung galaxy s7 (requires additional micro-b cable or otg adapter), samsung galaxy s8/ s8+, samsung galaxy s9/ s9+. Note that not all android devices provide enough power or support usb audio. Note that the mv88+ is not compatible with ipad pro.
0.6 mil Diamond conical tip needle , 16 or 33 or 45rpm NOT for 78rpm , 1,5 – 2,5 grams tracking pressure
0.7 mil Diamond conical tip needle ,for 78rpm , 3,0 – 5.0 grams tracking pressure
0.7 mil Diamond conical tip needle , 16 or 33 or 45rpm NOT for 78rpm , 2.5- 3.5 grams tracking pressure
0.7 mil Diamond conical tip needle , 16 or 33 or 45rpm NOT for 78rpm , 1,0 – 1,5 grams tracking pressure
Orders shipped within 24 hours
Ortofon stylus for Ortofon OM 20 OM20 phono cartridge with 0.3 x 0.7 mil nude elliptical diamond.
$ 152.95
Out of stock
Black
Generic
Elliptical
no
0MB-10, 0MB-1O, 0MB10, 0MB1O, LM-10, LM10, OM-5 E, OM-PRO, OM5E, OMB-10, OMB10, OMPRO, STD, TM-10, TM-1O, TM10, TM1O
16, 33, 45
759-DEJC
1,5 grams
Audio Technica VMN30EN stylus specified for VM530EN Cartridge, Aluminum cantilever , 0.3 x 0.7 mil Diamond elliptical needle, 1.8-2.2 grams (2.0 g standard) tracking pressure
Audio-Technica ATN-91R stylus specified forAT91R and CN5625AL cartridges, Special conical diamond tip for good fidelity ,06 Diamond conical Replacement Stylus with Bonded Round Shank , 2 – 4 grams tracking pressure
0.7 mil Diamond conical tip needle , 16 or 33 or 45rpm NOT for 78rpm, 1,0 – 3,0 grams tracking pressure
Audio-Technica AT-VMN95E stylus specified for AT-VM95E cartridge, Special elliptical diamond tip for good fidelity , 0.3 x 0.7 mil Diamond Elliptical needle , 1.8 – 2.2 grams tracking pressure